Skip to content

Miura Rear Louvers

January 13, 2014

I could not believe how much paint was on these louvers. If I would have sent them out to the blaster to remove the material that was on them I believe the outside of the aluminum would have been ruined. We chose to hand chemical strip the louvers to remove the majority of the paint first before media blasting. Good call… because they hardly needed any surfacing. We went with a heat resistant primer first to play it safe for motor high heat temp escaping.

Leave a Comment

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: